Showing 19–27 of 30 results

  • RECIPROCATING FRICTION & WEAR TEST RIG TE-200-SRF

    The Reciprocating Friction & Wear Test Rig is versatile digitally controlled equipment to test various metals, coatings under reciprocating sliding contact at various load & sliding frequencies under dry & lubricated (with oil & grease) condition.

  • ROLL STABILITY TESTER TE-250-RST

    Conforms to ASTM D 1831, D 7342 Rugged by designed for long run test Variable speed 10 to 600 rpm Preset timer 99hrs:59min:59sec High precision preset temperature controller Uniform heat distribution with high quality thermal insulation entire chamber Test cylinders & roller are made of stainless steel

  • ROTARY BENDING FATIGUE TEST RIG CANTILEVER TYPE – TE-200-CLT

    Application

    The Rotary Bending Fatigue Test Rig is used to test the fatigue strength of metals or other materials under bending & rotating when subject an ALTERNATING STRESS.

  • SCALE TEST RIG / BRAKE MATERIAL TEST RIG TE-500-STR

    Application

    The scale test rig for wear testing of friction materials is preliminarily intended for evaluation of the fade and recovery & wear characteristics of friction materials.

    Used in quality control & comparative testing of brake materials.

  • SCRATCH TESTER TE-200-STR

    Application

    The Scratch Tester is used to test adhesion of this coatings of flat surfaces, testing is carried out using rock well ‘C’ diamond indenter on a coated test piece to measure the critical loads at which a coating fails.

  • SLURRY ABRASION TEST RIG TE-178-SAT

    Application
    To determine the resistance of metallic materials to scratching wet sand & rubber wheel test.

  • SLURRY EROSIVE WEAR TESTER TE-120-SEW

    Application
    The Slurry Erosive Wear Tester is used to test the erosive resistance of solid materials to slurry compositions various materials can be tested such as polymers, plastics, hard materials etc.,

  • THRUST WASHER TEST RIG TE-200-TWT

    Application 

    To study the friction and wear in thrust washer, clutch plate facing materials in dry or fluid filled environment.

  • TRIBO TEST MATE – TE-1250-SFT

    Application

    The Tribo Test Mate is a unique instrumented state of the art tribometer used for assessing the tribological behavior of lubricants and coolants. The principal of operation consist of drawing or sliding test samples against a stationery counter surface under load and recording the parameters of interest.