Showing 1–9 of 30 results

  • AIR JET EROSION TEST RIG TE-400-HMI

    Application

    • The air jet erosion tester is used to test the erosion resistance of solid materials to a stream of gas containing abrasive particles.

    • Materials such as metals, ceramics, minerals, polymers, composites, abrasive and coatings can be tested with this instrument.

    • The test specimen, temperature, angle of incidence of the jet stream, abrasive particulate speed and flux density, can be varied to best simulate actual conditions.

  • AIR JET EROSION TEST RIG TE-400-STD

    Application

    • The air jet erosion tester is used to test the erosion resistance of solid materials to a stream of gas containing abrasive particles.

    • Materials such as metals, ceramics, minerals, polymers, composites, abrasive and coatings can be tested with this instrument.

    • The test specimen, temperature, angle of incidence of the jet stream, abrasive particulate speed and flux density, can be varied to best simulate actual conditions.
  • DRY SAND ABRASION TEST RIG / THREE BODY ABRASION TEST RIG TE-228-DAT

    Application
    To Test the abrasive resistance of solid materials to abrasive dry sand compositions. Materials such as metals, minerals, polymers, composites, ceramics, abrasives and thick coatings can be tested with this instrument.
    To develop a comparison table for ranking different materials with respect to each other, it is necessary to convert this mass loss to volume loss to account for the difference in material density.

  • FOUR BALL TESTER TE-800-FBT

    To determine the co-efficient of friction of lubricants, wear preventive (WP) & extreme pressure (EP) properties of lubricants characteristics of lubricating oils under variety test conditions.

  • FOUR POINT ROTARY BENDING FATIGUE TEST RIG – TE-400-FPT

    Application

    Four Point Rotary Bending Fatigue Test Rig is used to study the fatigue failure of materials when subject to constant bending movement.

  • GREASE LEAKAGE TENDENCIES TESTER TE-105-GLT

    Application 

    Evaluation of the leakage tendencies of wheel bearing greases tested under prescribed laboratory conditions.

  • HIGH TEMPERATURE AIR JET EROSION TEST RIG TE-800-HTA

    Application

    The High Temperature Air Jet Erosion Test Method broadly covers the ASTM G 76 standard. This test method covers determination of erosion rate by solid particle impingement in a gas steam.

  • HIGH TEMPERATURE HIGH FREQUENCY FRICTION & WEAR TEST RIG TE-300-HTR

    Conforms to ASTM G 133-05 Repeatable friction & wear measurement Independent proven repeatability Easy to calibrate Compact standalone bench top system

  • HIGH TEMPERATURE PIN ON DISC FRICTION & WEAR TEST RIG TE-80-HTP

    Application

    The High Temperature Pin On Disc Friction & Wear Test Rig is primarily intended for determining the tribological characteristics of wide range of materials under high temperature & vacuum condition to evaluate the wear and friction characteristics of real life condition.